Rlide R2 Series - Coordinates Stakeout

49
Press
HOT Key
1.Input HT
2.Temp&Pres
3.TGT
4.Note
Press [ENT]
Input HT
HT:
1.800m
Stac
When the cursor is on “Input ht”, Press
[ENT] to enter to Input HT function.
After inputting the height of the target,
press [ENT] to return to page 2/8 of SO.
SO
3/8
AZ:
15°42’13”
HD:
2.359m
VD:
-0.183m
* Press [MSR] 1 Sec.
Change meas mode
Press [MSR1] or [MSR2]
<MSR1>
TGT:
Prism
Const:
-30mm
Mode:
Fine[s]
Rec:
All
This page displays the horizontal distance
measurement of target prism. Press
[MSR1] or [MSR 2] for 1 second to
change the measure mode.
Press [▲] or [▼] moving to the item
needed to rectify, press [ ] or [ ] to
change.
TGT：Prism, non-prism, reflector sheet
Const：Enter the prism constant directly
(In prism mode)
Mode：Fine[s]、Fine[2](3/4/5), Fine[r],
Tracking
Rec: Meas, Enter, All
SO
4/8
HL:
344°17’46”
V%:
70.07%
Z:
1.236m
* Press [DSP] 1 Sec.
Display user-defined
Press [DSP] for 1 second
<DSP1>
<DSP2>
<DSP3>
HA
AZ
HL
VA
HD
V%
SD
VD
Z
* Change Use /
Save
User can change the memory taken up
by display screen. Press [ ]/[ ]，
[▲]/[▼] to select, and use /
softkey to change, press [ENT] or [Save]
to make the rectification valid.