Rlide R2 Series - Page 90

88
b.
Select “Define VT AL”.
[1]
VT Alignment
1.
Define VT AL
2.
Edit VT AL
3.
Receive VT AL
4.
Delete VT AL
c.
Input chainage, elevation and length,
then press [ENT].
The length of start point and end point
must be 0.
Input chainage,
elevation and
length
[ENT]
Define VT AL
01
CH:
10.000
ELEV:
20.000m
Len:
0.000m
d.
At the bottom of the screen “Complete”
displays, saving this alignment data, the
display returns to Define VT AL screen to
continue inputting the next alignment.
Define VT AL
01
CH:
0.000
ELEV:
0.000m
Len:
0.000m
7.7.6 Edit Vertical Alignment Data
It is able to be applied to edit vertical alignment data. The operation steps are similar to that of editing
horizontal alignment.
STEP
OPERATION
DISPLAY
a.
In VT Alignment select “Edit VT AL”.
[2]
VT Alignment
1.
Define VT AL
2.
Edit VT AL
3.
Receive VT AL
4.
Delete VT AL
b.
Screen displays the first Vertical
alignment. Use softkey [Next] to find
other alignment that needs to be edited.
[Next]
Edit VT AL
01/05
CH:
10.000
ELEV:
10.000m
Len:
0.000m
End
Next