Rlide R2 Series - Page 92

90
7.7.8 Stn Setup
You can use chainage to setup station when there is horizontal alignment data in internal memory.
STEP
OPERATION
DISPLAY
a.
In Roads menu select“3.Stn Setup”.
[3]
Roads
1.
HZ Alignment
2.
VT Alignment
3.
Stn Setup
4.
Stake Out Roads
b.
hen there is horizontal alignment data in
memory, you can use [CH] to setup
station. Other method to setup station,
please refer to Session 4. Key.
Press [CH] to start.
[CH]
Input STN
ST:
1
HI:
1.000m
CD:
CH
List
Stac
c.
Input the chainage and press [ENT].
Make sure the input chainage is on the
designed horizontal alignment. Press
[PT] to enter to setting up station by point
function, refer to Session 4. Key.
Input chainage
[ENT]
Input STN
CH:
1
OF:
0.000m
HI:
0.000m
PT
d.
In OF item input the offset of the
chainage to center line. And press [ENT].
Input Offset
[ENT]
Input STN
CH:
100.00
1
OF:
0.000m
HI:
0.000m
PT
e.
The screen displays detailed data about
the chainage. Input height of instrument
and press [ENT].
Input height of
instrument
[ENT]
Input STN
CH:
100.00
1
OF:
1.000m
HI:
0.000m
PT