AX10 Palletizing Solution
10.2. PowerPick10 Vacuum Gripper (Optional)
If the desired vacuum level cannot be reached or if a loss of vacuum occurs:
l
Verify the feed pressure level; adjust accordingly
l
Inspect the condition of the suction cups; replace if necessary
l
Make sure that the air path, including the manifold, is clean and unobstructed
l
Inspect the air filter; clean if necessary
CAUTION
Unless specified, any repairs performed on the Vacuum Gripper or Vacuum Generator should be done
by Robotiq, otherwise the warranty will be void.
For more information on troubleshooting the PowerPick10 Vacuum Gripper, please refer to the Troubleshooting section of the
PowerPick10 user manual, available at support.robotiq.com. If necessary, send an inquiry to the support team at :
support@robotiq.com.
To Next Page
Loading...
