ROBOTIQ AX10 - Page 16

AX10 Palletizing Solution
l
If necessary, secure the maintenance and repair area with temporary barriers.
l
Before performing repair work, clean the affected parts, especially the connections and fittings.
l
Install the Solution in a safe position. Depending on the maintenance and repair work to carry out, parts may come loose and
cause injury.
WARNING
l
Maintenance and repair work on electrical equipment must be carried out by qualified and
authorized personnel.
l
Do not bring electrical components into contact with cleaning agents. Electrical components
should only be cleaned when the Palletizing Solution is turned off and de-energized.
l
After having performed maintenance and repair work, verify screw torque and adjust accordingly if required.
l
If the dismantling of safety equipment is necessary before performing maintenance or repair work, the equipment must be
reinstalled and assessed immediately after completion of said work.
l
Use original spare parts exclusively.
l
Perform preventive maintenance and cleaning work at regular intervals according to the Periodic Inspection and Maintenance
section.
Risk of Accident
WARNING
During maintenance, there is an increased risk of accident due to the parts, tools and equipment
used in and around the Palletizing Solution area.
l
Slip, trip and fall hazards can be avoided by maintaining order and cleanliness in the workplace.
l
For work in elevated positions (500 mm and more), fall protection equipment must be installed and used.
l
When dismantling or replacing machine parts in elevated positions (500 mm and more), suitable lifting devices should be used.
Hot Surfaces
The proper use of the Palletizing Solution does not create hot surfaces.
If surfaces get hot, please stop using the Solution and contact the Robotiq support team.
Radiation
The proper use of the Palletizing Solution does not create non-ionizing radiation.
Pneumatic Limitations
l
The maximum permissible pressure for all pneumatic components must never be exceeded.
l
Pneumatic tubing must be checked at regular intervals and replaced if necessary.
16