Robotiq Screwdriving Solution - Instruction Manual
8.1.1.Cleaning
OPERATION WEEKLY MONTHLY
Inlet filter cleaning Dirty conditions Normal conditions
Muffler cleaning Dirty conditions Normal conditions
Caution
Without additional protection, the Screwdriver is not waterproof or water resistant. Therefore, clean the Screwdriver
using a dry towel.
Caution
Make sure to depressurize the air supply before you start removing the Screwdriver from its coupling or before
performing any cleaning actions.
Inlet Filters
MAINTENANCEINTERVAL REQUIRED TOOLS REQUIRED PARTS
l
Weekly (normal operating conditions)
l
Daily (heavy dirt/dust-filled environments)
l
Dry or slightly damp lint-free cloth
l
Flat head screwdriver
Replacement filter
(if applicable)
1. Remove the nozzle by removing the four screws and Belleville washer
2. Remove the inlet filter covers with a flat head screwdriver
3. Clean dirt, dust, debrisand other contaminantsfrom the four filter using a dry or slightly damp lint-free cloth
Info
Replace any damaged filter to ensure efficient Screwdriver operation.
Please refer to the Spare Parts, Kitsand Accessoriessection for replacement filters reference.
4. Put the filtersand their covers back on
5. Put the nozzle back in place, and secure using the four screws and Belleville washer (convex side upwards)
78
To Next Page
Loading...
