SPECIAL DIMENSIONS BY CHANGING THE SETTINGS
Sometimes it is necessary to produce something out of line, e.g. a screw conveyor with a very
high pitch. In such cases, you can „play“ with the settings to get there. For example, in the
settings you can temporarily halve the number of encoder pulses to double the feed rate. Of
course you have to take the change into account.
Also at settings, drive of Z-axis can be reversed temporarily, e.g. to turn right side. Of course
you have to keep in mind that the Z-axis then moves exactly the other way round than usual,
even when moving manually!
MOVING THE X AXIS MANUALLY IN GEAR MODE
In gear mode, the X axis can be deactivated with the XOFF key to move it manually.
99
To Next Page
Loading...