55
Tip 1:
The number of passes can also be turned to 1, then 1x to full depth. This is useful if you want to
turn to full depth again, e.g. when threading to remove the last hundreds of the material from
the thread groove.
Tip 2:
In the parameter menu of many cycles, the nishing feedrate can be set, which is the feedrate
for nishing. This allows you to set a dierent feed rate for the nishing operation than for the
roughing operation, usually a slower one. Saves time on longer operations!
POSSIBLE CYCLES
The following cycles are available:
● Gearbox Left - Electronic gear Left
● Gearbox Right- Electronic gear Right
● Turning - External long turning
● Boring- Internal long turning
● Facing
● Parting
● Undercut
● External thread - Straight or tapered thread External
● Internal thread - Straight or tapered thread Internal
● Thread <0 - External thread Never exceeding 0
● External taper
● Internal Taper
● Convex outer radius (
● Concave outer radius )
● Convex inner radius (
● Concave inner radius )
● Concave groove - Round or elliptical grooves
● Grinding- Grinding and pushing with spindle angle stationary or rotating -
● Drilling - Drilling cycle
● Angle measurement on chuck
To Next Page
Loading...