25
MICRO-SD-CARD-SLOT
The slot for a micro SD card is located on the right side of the housing. Such a memory card can
be used to update the software of the controller. Thus a simple update without PC is necessary,
directly at the installation location. See software update.
Commercially available memory cards of 2-32GB with FAT32 formatting are compatible.
PROGRAMKEY /SETTINGS RESET
On the right side of the housing there is also a small button.
For a software update this button is kept pressed when switching on.
Factory Reset:
In normal operation this button can also be used to set the settings to factory defaults. The
button is held for 7 seconds. A warning message in the display must be conī “rmed to reset the
settings.
ATTENTION: This function deletes all settings deviating from the factory settings!
To Next Page
Loading...