Rocketronics ELS 4 Basic - Appendix 2: Wall Mounting

106 pages

Save Page as PDF

To Next Page

To Previous Page

APPENDIX 2: WALL MOUNTING

On the back there is a retaining bracket for wall mounting. In addition, a wall bracket is avail-

able that can be adjusted in all axes and mounted with screws. How to adjust and fasten the

control optimally.

102

Main Page

Table of Contents4
Addressee of the Documentation6
Disclaimer6
Safety Instructions6
Licence Conditions for Software of the Electronic Leadscrew Control System7
Notes8
Scope of Delivery and Accessories12
Basic Requirements13
- Encoder14
- Axle Drives16
- Selection of Right Motor18
- Maximum Feed Speed19
- Motor-Drivers21
- Emergency-STOP22
Controlelements24
- Front Side24
- Key Functions25
- Display-Elements26
- Light Emitting Dioded (Led)26
- Micro-SD-Card-Slot27
- Programkey /Settings Reset27
- Inputs and Outputs28
- Screwterminal Data29
- Power Supply29
- Extension Connector29
- Grounding29
- Connection of Encoder30
- Connection Motordriver32
- Digital Inputs34
- Emergency Stop35
- Digital Outputs37
- Grounding, Cable and Shielding39
- System Connection Diagram40
Setup41
- SETUP General42
- Setup Encoder42
- SETUP Z-Motor43
- SETUP X-Motor44
- Setup Data45
- Setup Inputs46
- SETUP Outputs47
- Setup Information47
- Factory Settings47
Commissioning48
- Preparations48
- Checklist before Commissioning49
- Implementation of the Commissioning50
Basic Functionality54
- Selection of Cutting Passes56
Possible Cycles57
- Gearbox Left58
- Gearbox Right58
- Turning60
- Boring64
- Facing66
- Parting68
- Undercut69
- Making Threads71
- External Cone80
- Internal Cone82
- Radius Turning in General84
- E-Radius ) External Radius Konvex85
- E-Radius87
- I-Radius ) Internal Radius Convex89
- I-Radius91
- Groove93
- Grinding98
- Angle99
Tips for Use100
- Approach Positions Exactly100
- Set the Zero Point on the Workpiece Surface100
- Drive from Waiting Position to 0100
- Precise External Turning Made Easy100
- Special Dimensions by Changing the Settings101
- Moving the X Axis Manually in Gear Mode101
Softwareupdate102
Appendix 1 Definition of Cone Ratio103
Appendix 2: Wall Mounting104
Appendix 3: Technical Data105
Contact Us106
Disposal106

Rocketronics ELS 4 Basic - Appendix 2: Wall Mounting

Table of Contents