Rocketronics ELS 4 Basic - Page 65

nishing.
Limitations in dimensions: None
Maximum speed: 3000 rpm
The speed can be freely changed during the cut. A stop can be made at any time by pressing
the STOP button.
There are three possible variants:
1. ZP = 0 and XP = 0 so there are no endpoints at all specied, in which case the movement
after the START signal goes to X 0,00 after a safety query and then in the -Z direction until the
STOP key is pressed. START-Stop operation is possible while the vehicle is in motion. The move-
ment is aborted only when the STOP button is pressed, after which X and Z are reset to the stop
position.
2. ZP <> 0 XP = 0, therefore only one end position for Z is specied, no depth. Here the
movement goes directly after the START signal WITHOUT safety query to X 0.00 and then in
-Z direction to the end point Z P. Then a reset to X 0.2 and back to Z 0.00 takes place, then the
position for X and Z changes to the hold position.
3. ZP < 0 and XP < 0, so the values for length and depth are given here. the cutting is fully
automatic in several passes. after the START signal, the controller rst displays all the data for
the individual passes in an overview and then starts again after a new start command. Here you
can also abort by pressing the STOP key.
63