Moving axes and directions:
• X towards the chuck (-X)
• Z towards the chuck (-Z)
Required data:
• Feed F in mm/U
• ZP: Machining length in Z direction, must be zero or negative
• XP: Cutting depth in X-direction, must be zero or negative.
Available parameters in the parameter menu:
The parameter menu allows quick access to useful settings. It can be reached by navigating
down with the DOWN key. If you change from Feed -> ZP -> XP further down, you enter the
parameter menu. Exit the menu by pressing the HIGH key or LEFT.
● X Ap Finish - Depth of the last nishing pass in mm.
● Finish feed rate - Speed of the nishing pass, either as a percentage of the feed rate set, or if
it continues to exceed 100%, also in discrete values in mm/revolution. The roughing pass is
then carried out at the feed rate set in the mode, the last nishing pass at the speed set here
in the parameter menu. So you can roughen quickly and nish slowly to save time.
● Tool Corner Radius - The radius of the cutting edge, an important information to be able to
rotate the radius and the slope exactly.
68
To Next Page
Loading...