Intended use
The ELS controller is used to control stepper or servo motors (or similar drives) for operation
on a lathe. Any other use is considered improper.
Supplied accessories such as power supply units, output stages, sensors or motors must only
be used for their intended purpose.
Disclaimer
Rocketronics produces components that are used on a wide variety of lathes. The selection and
application of Rocketronics products is the responsibility of the system designer or end user.
Rocketronics assumes no responsibility for the integration of the products into the end system.
Under no circumstances may a Rocketronics product be integrated into a product or design as
a safety controller. All products containing a component part manufactured by Rocketronics
must include appropriate warnings and instructions for safe use and operation when handed
over to the end user. All warnings provided by Rocketronics must be passed directly to the end
user.
The user of this control must ensure that all necessary safety precautions have been taken and
that they have been checked for correct operation to ensure safe operation of the machine.
When a lathe is modied, a potentially dangerous device is modied. The automation of move-
ments can cause damage to the machine, but also serious injuries to the operating personnel.
WARNING
If incorrect entries are made, the machine equipped with this control
may make unexpected movements which can be fatal for the operating
personnel. It is therefore the responsibility of the system designer or
end user to ensure that the settings are correct and have been checked.
7
To Next Page
Loading...