Roger Technology H70/104AC Instructions And Warnings For Installation

EN
55
NOTA-JSRISVQSVIGSRXEGXWEVISTIRXLIKEXI[MPPRSXSTIRSVGPSWI8LMWHSIWRSXETTP]JSVXLIPMQMXW[MXGLWMKREP
WXEXILS[IZIV[LMGLMWWLS[RSRXLIHMWTPE]FYXHSIWRSXTVIZIRXRSVQEPSTIVEXMSRSJXLIKEXI
-JQSVIXLERSRIWEJIX]HIZMGIMWMREPEVQWXEXISRGIXLITVSFPIQVIPEXMZIXSXLIƼVWXHIZMGIMWVIWSPZIHXLIEPEVQJSV
the next device is displayed. Any further alarm states are also displayed with the same logic.
Press the TEST button again to exit test mode.
%JXIVWIGSRHW[MXLRSYWIVMRTYXXLIHMWTPE]VIXYVRWXSGSQQERHERHWEJIX]HIZMGIWXEXIHMWTPE]QSHI
• Standby mode
8LMWQSHIMWEGXMZEXIHEJXIVQMRYXIW[MXLRSYWIVMRTYX8LI43;)60)(ƽEWLIWWPS[P]
Press UP a(3;2b
+
- to reactivate the control unit.
POWER
11 Travel acquisition
*SVXLIW]WXIQXSJYRGXMSRGSVVIGXP]XLIKEXIXVEZIPQYWXFIEGUYMVIHF]XLIGSRXVSP
&IJSVIWXEVXMRK
1. Select the position of the motor relative to the gate with the parameter . The default setting for this parameter
is with the motor installed on the right hand side of the gate (seen from interior side).
2. Check that the operator present function is not enabled ($).
3. Install mechanical stops in both the open and closed positions.
4. Move the gate into an intermediate position.
5. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any safety
HIZMGIWEVIRSXMRWXEPPIHNYQTIVXLIVIPEXMZIGSRXEGXSVHMWEFPIXLIHIZMGIJVSQXLIVIPEXMZITEVEQIXIV (
 and ).
6. 7IPIGXXLIETTVSTVMEXIWIPJEGUYMWMXMSRTVSGIHYVIJSV]SYVMRWXEPPEXMSR
A
SELF-ACQUISITION PROCEDURE WITH ENCODER ENABLED, WITH OR WITHOUT LIMIT
SWITCHES (see paragraph 11.1).
B
SELF-ACQUISITION PROCEDURE WITH LIMIT SWITCHES, WITHOUT ENCODER (see paragraph
11.2).
C
SELF-ACQUISITION PROCEDURE WITHOUT LIMIT SWITCHES AND WITHOUT ENCODER
(see paragraph 11.3).

Roger Technology H70/104AC Specifications

General

Brand	Roger Technology
Model	H70/104AC
Category	Control Unit
Language	English