Roger Technology H70/104AC - Enable Double Manoeuvre Time; Gate Fully Open;Closed Position Control Setting; Gate Open Indicator; Photocell Test Function; Partial Opening Adjustment (%)

EN
62

Enabled. The open (AP) or close (CH) button must be pressed continuously to operate the gate. The gate
stops when the button is released.
D 
Gate open indicator / photocell test function

8LIMRHMGEXSVMWSJJ[LIRXLIKEXIMWGPSWIHERHWXIEHMP]PMXHYVMRKQERSIYZVIWERH[LIRXLIKEXIMW
open.

8LIMRHMGEXSVƽEWLIWWPS[P]HYVMRKSTIRMRKQERSIYZVIWERHMWPMXWXIEHMP][LIRXLIKEXIMWGSQTPIXIP]
STIR-XƽEWLIWUYMGOP]HYVMRKGPSWMRKQERSIYZVIW
-JXLIKEXIMWWXSTTIHMRERMRXIVQIHMEXITSWMXMSRXLIPEQTI\XMRKYMWLIWX[MGIIZIV]WIGSRHW

Set  if the output SCMWYWIHJSVXLITLSXSGIPPXIWX7IIƼK
  
Set motor deceleration space (%)
N.B.: MJRSIRGSHIVMWMRWXEPPIHVITIEXXLIXVEZIPEGUYMWMXMSRTVSGIHYVIEJXIVER]GLERKIQEHIXSXLMW
parameter.

From 1% to 30% of the total gate travel.
 
Gate fully open/closed position control setting
The value selected must ensure that the gate is opened/closed correctly when it reaches the respective
mechanical stop.
Warning! Excessively low values cause the gate to reverse when it reaches the gate open/closed stop.
N.B.: parameter visible only with encoder enabled (  or  ) and if limit switches are not instal-
led (  or  ).

Motor revolutions.
 
Partial opening adjustment (%)
N.B.8LMWTEVEQIXIVMWWIXXSSJXSXEPKEXIXVEZIPF]HIJEYPX

From 1% to 99% of total gate travel.
 
Setting additional time after direction inversion, with no encoder
N.B.: parameter visible only if encoder is disabled  .
-RXLIIZIRX SJTLSXSGIPPEGXMZEXMSRSVEVIZIVWIGSQQERHHYVMRKERSTIRMRKSVGPSWMRKQERSIYZVI
the gate reverses for the elapsed manoeuvre time plus an additional time to allow the manoeuvre to be
completed.

3 s.

6 s. Recommended setting for installations with hydraulic motors.
  
Setting automatic closing time
8LIXMQIVWXEVXWJVSQXLIKEXISTIRWXEXIERHGSRXMRYIWJSVXLIWIXXMQI3RGIXLIWIXXMQIMWVIEGLIH
the gate closes automatically. The timer count restarts if a photocell is triggered.

Pause time settable from 00 to 90 s.

Pause time settable from 2 to 9 min.
 
Set manoeuvre time
N.B.: parameter visible only if encoder is disabled  .
Warning! 1SHMJ]MRKXLMWTEVEQIXIVMRƽYIRGIWXLIHIGIPIVEXMSRWIXXMRKTEVEQIXIV).

Manoeuvre time settable from 00 to 99 s.
 
Enable double manoeuvre time
Enabling this parameter is recommended for installations with particularly long operating times.
N.B.: parameter visible only if encoder is disabled  .

Disabled.

Enabled.