EasyManua.ls Logo

Roger Technology H70/104AC - Automatic Close after Pause Time (from Gate Completely Open); Automatic Gate Closing after Mains Power Outage (Black-Out); Condominium Function for Partial Open Command (PED); Enabling Operator Present Function

Roger Technology H70/104AC
260 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
61
13 Parameter menu
PARAMETER PARAMETER
VALUE
$
Automatic closure after pause time (from gate completely open)

Disabled.

From 1 to 15 of gate closure attempts after photocell is triggered.
3RGIXLIRYQFIVSJEXXIQTXWWIXMWVIEGLIHXLIKEXIVIQEMRWSTIR

8LIKEXIXVMIWXSGPSWIMRHIƼRMXIP]
$
Automatic gate closing after mains power outage

Disabled. The gate does not close automatically when mains power is restored.

)REFPIH-JXLIKEXIMW238GSQTPIXIP]STIR[LIRQEMRWTS[IVMWVIWXSVIHXLIKEXIGPSWIWEJXIVE
WIGSRH[EVRMRKWMKREPPIH[MXLXLIƽEWLMRKPMKLXMRHITIRHIRXP]SJXLIZEPYIWIX[MXLXLITEVEQIXIV$).
The gate closes in “position recovery” mode (see chapter 17).
$ 
Selecting step mode control function (PP)

Open-stop-close-stop-open-stop-close...

'SRHSQMRMYQJYRGXMSRXLIKEXISTIRWERHGPSWIWEJXIVXLIWIXEYXSQEXMGGPSWMRKXMQI
The automatic closing timer restarts if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open completely and
prevents the gate from closing when not required.
If automatic closing is disabled ($ XLIGSRHSQMRMYQJYRGXMSREYXSQEXMGEPP]EXXIQTXWEGPSWMRK
manoeuvre $ .

'SRHSQMRMYQJYRGXMSRXLIKEXISTIRWERHGPSWIWEJXIVXLIWIXEYXSQEXMGGPSWMRKXMQI
The automatic closing timer does NOT restart if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open completely and
prevents the gate from closing when not required.
If automatic closing is disabled ($ XLIGSRHSQMRMYQJYRGXMSREYXSQEXMGEPP]EXXIQTXWEGPSWMRK
manoeuvre $ .

Open-close-open-close.

Open-close-stop-open.
D
4VIƽEWLMRK

(MWEFPIH8LIƽEWLMRKPMKLXMWEGXMZEXIHHYVMRKSTIRMRKERHGPSWMRKQERSIYZVIW

Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.

WIGSRHƽEWLMRK[EVRMRKWMKREPTVMSVXSGPSWMRKQERSIYZVI
D
Condominium function for partial open command (PED)

(MWEFPIH8LIKEXISTIRWTEVXMEPP]MRWXITQSHISTIRWXSTGPSWIWXSTSTIR

Enabled. Partial commands are ignored during gate opening.
D 
Enabling operator present function

Disabled.

Table of Contents

Other manuals for Roger Technology H70/104AC

Related product manuals