Roger Technology H70/104AC - Password; View Control Unit Days on Counter

EN
68
K 
Manoeuvre hours.
)\EQTPI = 123 hours.
K 
View control unit days on counter
The number consists of the values of the parameters from G to G.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
G 
Days with unit switched on.
)\EQTPI = 123 days.
G 
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (&3=TEVEQIXIVWQE]FIZMI[IHFYXXLIZEPYIW'%2238FIQSHM-
ƼIH
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
3  
3 
3 
3 
Password activation procedure:
• Enter the desired values for parameters 333 and 3.
• Use the UP
a
and/or DOWN
b buttons to view the parameter &3.
• Press and hold the
+ and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRWEZIH
• Switch the control unit off and on again. Check that password protection is activated (&3=).
Temporary unlock procedure:
• Enter the password.
• Check that &3= .
Password cancellation procedure:
• Enter the password (&3=).
• Save the values 3333 = 
• Use the UP
a
and/or DOWN
b buttons to view the parameter &3.
• Press and hold the + and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRGERGIPPIHXLIZEPYIW3 3 3 
and 3  indicate that no password is set).
• Switch the control unit off and on again (&3=).
&3 
Changing password

Protection deactivated.

Protection activated.