To Next Page

To Previous Page

11.2 SELF-ACQUISITION PROCEDURE WITH LIMIT SWITCHES,

WITHOUT ENCODER (R30/1209 - G30/2205 SERIES)

WARNING: &IJSVIWXEVXMRKXLIWIPJEGUYMWMXMSRTVSGIHYVIWIXTEVEQIXIVW - Deceleration space setting.

PROG

TEST

AP P- AP 1

CH 1

x4 s

OPENING

OPEN

CLOSING

TEST

Yes

PROG

1 click

x2 s

See safety input (Chap. 14) and

Alarm and fault (Chap. 15)

• /IITE[E]JVSQXLITLSXSGIPPFIEQXSTVIZIRXMRXIVVYTXMRKXLITVSGIHYVI

• Press and hold PROG for 4 seconds. $3 3 is shown on the display.

• Press PROG again.

• The gate starts an opening manoeuvre at the speed selected in par. . $3is shown on the display.

• 3RGIXLIVIPEXMZIPMQMXW[MXGLMWEGXMZEXIHXLIKEXIWXSTWFVMIƽ]

• SDƽEWLIWSRXLIHMWTPE]JSVWIGSRHW

• %JXIVXLMWWIGSRHMRXIVZEPKEXIGPSWIWEYXSQEXMGEPP]8LIQIWWEKI&+ appears on the display.

• The self-acquisition procedure concludes when gate reaches the closed limit switch.

• -JXLIEGUYMWMXMSRTVSGIHYVIMWGSQTPIXIHWYGGIWWJYPP]XLIHMWTPE]IRXIVWXLIGSQQERHERHWEJIX]HIZMGIWXEXI

display mode.

-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI

• $33(acquisition error4VIWWXLI8)78FYXXSRXSGPIEVXLIIVVSVERHGLIGOXLIWEJIX]HIZMGIMREPEVQWXEXI

LFor more information, see chapter 16 “Alarms and faults”.

Roger Technology H70/104AC Instructions And Warnings For Installation

Other manuals for Roger Technology H70/104AC