Analysis
R&S
®
FSW-K7
136User Manual 1173.9240.02 ─ 17
Marker State
Activates or deactivates the marker in the diagram.
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 301
CALCulate<n>:DELTamarker<m>[:STATe] on page 304
Marker Position (X-value)
Defines the position (x-value) of the marker in the diagram.
Remote command:
CALCulate<n>:MARKer<m>:X on page 301
CALCulate<n>:DELTamarker<m>:X on page 305
Marker Type
Toggles the marker type.
The type for marker 1 is always "Normal", the type for delta marker 1 is always "Delta".
These types cannot be changed.
Note: If normal marker 1 is the active marker, switching the "Mkr Type" activates an
additional delta marker 1. For any other marker, switching the marker type does not
activate an additional marker, it only switches the type of the selected marker.
"Normal"
A normal marker indicates the absolute value at the defined position
in the diagram.
"Delta"
A delta marker defines the value of the marker relative to the speci-
fied reference marker (marker 1 by default).
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 301
CALCulate<n>:DELTamarker<m>[:STATe] on page 304
Reference Marker
Defines a marker as the reference marker which is used to determine relative analysis
results (delta marker values).
If a fixed reference point is configured (see "Defining a Fixed Reference"
on page 138), the reference point ("FXD") can also be selected instead of another
marker.
Remote command:
CALCulate<n>:DELTamarker<m>:MREF on page 304
Linking to Another Marker
Links the current marker to the marker selected from the list of active markers. If the x-
axis value of the inital marker is changed, the linked marker follows on the same x-
position. Linking is off by default.
Marker Settings
To Next Page
Loading...
