Rohde & Schwarz FSW Series - Page 259

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
259User Manual 1173.9240.02 ─ 17
Manual operation: See "AF Center" on page 111
[SENSe:]ADEMod:AF:SPAN <Span>
This command sets the span (around the center frequency) for AF spectrum result dis-
play.
The span is limited to DBW/2 (see [SENSe:]BANDwidth|BWIDth:DEMod
on page 242).
Parameters:
<Span> *RST: 9 MHz
Example:
ADEM:AF:SPAN 200 kHz
Sets the AF span to 200 kHz
Manual operation: See "AF Span" on page 111
[SENSe:]ADEMod:AF:SPAN:FULL
This command sets the maximum span for AF spectrum result display.
The maximum span corresponds to DBW/2 (see [SENSe:]BANDwidth|BWIDth:
DEMod on page 242).
Example:
ADEM:BAND 5 MHz
Sets the demodulation bandwidth to 5 MHz
ADEM:AF:SPAN:FULL
Sets the AF span to 2.5 MHz
Manual operation: See "AF Full Span" on page 112
[SENSe:]ADEMod:AF:STARt <Frequency>
This command sets the start frequency for AF spectrum result display.
Parameters:
<Frequency> *RST: 0 MHz
Example:
ADEM:AF:STAR 0 kHz
Sets the AF start frequency to 0 kHz
ADEM:AF:STOP 500 kHz
Sets the AF stop frequency to 500 kHz
Manual operation: See "AF Start" on page 111
[SENSe:]ADEMod:AF:STOP <Frequency>
This command sets the stop frequency for AF spectrum result display.
Parameters:
<Frequency> *RST: 9 MHz
Configuring the Measurement