Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
286User Manual 1173.9240.02 ─ 17
Query parameters:
<WindowName> String containing the name of a window.
Return values:
<WindowIndex> Index number of the window.
Usage: Query only
LAYout:REMove[:WINDow] <WindowName>
This command removes a window from the display.
Parameters:
<WindowName> String containing the name of the window.
In the default state, the name of the window is its index.
Usage: Event
LAYout:
REPLace[:WINDow] <WindowName>,<WindowType>
This command replaces the window type (for example from "Diagram" to "Result Sum-
mary") of an already existing window while keeping its position, index and window
name.
To add a new window, use the LAYout:ADD[:WINDow]? command.
Parameters:
<WindowName> String containing the name of the existing window.
By default, the name of a window is the same as its index. To
determine the name and index of all active windows, use the
LAYout:CATalog[:WINDow]? query.
<WindowType> Type of result display you want to use in the existing window.
See LAYout:ADD[:WINDow]? on page 284 for a list of availa-
ble window types.
Example:
LAY:REPL:WIND '1',MTAB
Replaces the result display in window 1 with a marker table.
LAYout:SPLitter <Index1>,<Index2>,<Position>
This command changes the position of a splitter and thus controls the size of the win-
dows on each side of the splitter.
As opposed to the DISPlay[:WINDow<n>]:SIZE on page 283 command, the
LAYout:SPLitter changes the size of all windows to either side of the splitter per-
manently, it does not just maximize a single window temporarily.
Note that windows must have a certain minimum size. If the position you define con-
flicts with the minimum size of any of the affected windows, the command will not work,
but does not return an error.
Configuring the Result Display
To Next Page
Loading...
