Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
287User Manual 1173.9240.02 ─ 17
Fig. 11-1: SmartGrid coordinates for remote control of the splitters
Parameters:
<Index1> The index of one window the splitter controls.
<Index2> The index of a window on the other side of the splitter.
<Position> New vertical or horizontal position of the splitter as a fraction of
the screen area (without channel and status bar and softkey
menu).
The point of origin (x = 0, y = 0) is in the lower left corner of the
screen. The end point (x = 100, y = 100) is in the upper right cor-
ner of the screen. (See figure 11-1.)
The direction in which the splitter is moved depends on the
screen layout. If the windows are positioned horizontally, the
splitter also moves horizontally. If the windows are positioned
vertically, the splitter also moves vertically.
Range: 0 to 100
Example:
LAY:SPL 1,3,50
Moves the splitter between window 1 ('Frequency Sweep') and 3
('Marker Table') to the center (50%) of the screen, i.e. in the fig-
ure above, to the left.
Example:
LAY:SPL 1,4,70
Moves the splitter between window 1 ('Frequency Sweep') and 3
('Marker Peak List') towards the top (70%) of the screen.
The following commands have the exact same effect, as any
combination of windows above and below the splitter moves the
splitter vertically.
LAY:SPL 3,2,70
LAY:SPL 4,1,70
LAY:SPL 2,1,70
Configuring the Result Display
To Next Page
Loading...
