Rohde & Schwarz FSW Series - Page 306

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
306User Manual 1173.9240.02 ─ 17
The unit depends on the application of the command.
Table 11-5: Analog demodulation measurements
Parameter, measuring function or result display Output unit
AM result display (R&S FSW–K7)
% (lin)
dB (log)
FM result display (R&S FSW–K7)
Hz (lin)
dB (log)
PM result display (R&S FSW–K7)
rad | deg (lin)
dB (log)
RF result display (R&S FSW–K7)
dB (Range Log or Range Linear %)
% (Range Linear %)
Return values:
<Position> Position of the delta marker in relation to the reference marker or
the fixed reference.
Example:
INIT:CONT OFF
Switches to single sweep mode.
INIT;*WAI
Starts a sweep and waits for its end.
CALC:DELT2 ON
Switches on delta marker 2.
CALC:DELT2:Y?
Outputs measurement value of delta marker 2.
Usage: Query only
11.8.1.2 General Marker Settings
The following commands control general marker functionality.
See also "Fixed Reference Marker Settings" on page 312
CALCulate:MARKer:X:SSIZe.......................................................................................... 306
CALCulate:MARKer<m>:LINK.........................................................................................307
DISPlay:MTABle............................................................................................................ 307
CALCulate:MARKer:X:SSIZe <StepSize>
This command selects the marker step size mode.
The step size defines the distance the marker moves when you move it with the rotary
knob. It therefore takes effect in manual operation only.
Analyzing Results