Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
308User Manual 1173.9240.02 ─ 17
11.8.1.3 Marker Search Settings
The following commands define criteria for searches.
CALCulate<n>:MARKer:PEXCursion............................................................................... 308
CALCulate<n>:MARKer:PEXCursion <Excursion>
This command defines the peak excursion.
The peak excursion sets the requirements for a peak to be detected during a peak
search.
The unit depends on the measurement.
Application/Result display Unit
Spectrum dB
ADEMOD, RF dB
ADEMOD, AM PCT
ADEMOD, FM kHz
ADEMOD, PM RAD
Parameters:
<Excursion> The excursion is the distance to a trace maximum that must be
attained before a new maximum is recognized, or the distance to
a trace minimum that must be attained before a new minimum is
recognized
*RST: 5 PCT in AM displays, 50 kHz in FM displays, (0.5
RAD in PM displays)
Example:
CALC:MARK:PEXC 10dB
Defines peak excursion as 10 dB.
Manual operation: See "Peak Excursion" on page 140
11.8.1.4 Positioning the Marker
The following remote commands are required to position the marker on a trace.
● Positioning Markers ..............................................................................................308
● Positioning Delta Markers..................................................................................... 310
Positioning Markers
The following commands position markers on the trace.
CALCulate<n>:MARKer<m>:MAXimum:LEFT...................................................................309
CALCulate<n>:MARKer<m>:MAXimum:NEXT..................................................................309
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]................................................................ 309
CALCulate<n>:MARKer<m>:MAXimum:RIGHt..................................................................309
CALCulate<n>:MARKer<m>:MINimum:LEFT....................................................................309
Analyzing Results
To Next Page
Loading...
