Instrument Functions
NRP2
119User Manual 1173.9140.02 ─ 07
Fig. 4-48: Filter dialog box in Trace display mode
A | B | C | D
Tabs for selecting the sensor.
Note: In remote-control commands, select the sensor with the suffix in command
SENSe<[1]..4>:...
, i.e. choose suffix 1 for channel A, channel 2 for B, and so on.
Gate Avg No
Selects the averaging number for averaging the gated measurement results.
Trace Avg No
Selects the averaging number for averaging the traces.
Remote command:
[SENSe<[1]..4>]:TRACe:
AVERage:COUNt on page 284
Video BW
Selects the video filter bandwidth. This setting is available in the R&S NRP-Z8x wide-
band power sensors, otherwise it is fixed.
Available values are "Full", "5 MHz", "1.5 MHz", and "300 kHz".
Remote command:
[SENSe<[1]..4>]:BANDwidth:VIDeo on page 266
4.5.3.4 Trace function settings
The trace function settings are performed in the Window→Graph→"Dis-
play"→"Trace"→"Trace Function"
dialog box ("Trace&Statistics"
sensor mode).
Fig. 4-49: Trace function
Displaying traces
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
