Instrument Functions
NRP2
156User Manual 1173.9140.02 ─ 07
Fig. 4-86: I/O / I/O 2 tab
Mode
Selects the function of the TRIG IN / OUT2
connector. "Analog Out" and "Trigger In"
are available.
Note: For remote control, only suffix 2 is allowed in the command header for the set-
ting theTRIG IN / OUT2 connector functions.
Analog Out ← Mode
The output provides an analog voltage, which is proportional to the value displayed in
the selected window, e.g. "Window 1".
Fig. 4-87: I/O 2 mode / Analog Out
Remote command:
The state must be set to ON.
OUTPut:RECorder<[1]..2>[:
STATe]
on page 258
Window 1 2 3 4 ← Analog Out ← Mode
Selects the window the output refers to.
Only windows that are operated in "Dig" or "D&A" window mode are available for selec-
tion. See chapter 4.3.3.3, "Selecting the result display mode", on page 93 for the set-
ting the display mode.
Remote command:
OUTPut:RECorder<[1]..2>:FEED on page 255
System settings
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
