Instrument Functions
NRP2
155User Manual 1173.9140.02 ─ 07
Fig. 4-84: Out1 mode / TrigOut
The trigger signal is either supplied by one of the connected sensors, i.e. the trigger
master, or via the "TRIG IN / OUT2" socket, see
chapter 4.2.6, "Trigger settings",
on page 85.
Use the signal for example to synchronize externally connected instruments.
Remote command:
OUTPut:TRIGger[:STATe] on page 260
Off ← Mode
Deactivates port "OUT1 / TRIG OUT".
Fig. 4-85: Out1 mode / Off
Remote command:
Both states have to be set OFF.
OUTPut:RECorder<[1]..2>[:STATe]
on page 258
OUTPut:TTL[:STATe] on page 260
4.7.2.2 I/O 2 interface
This section describes the functions and settings of the analog trigger input / analog
output at the "TRIG IN / OUT2"
connector.
System settings
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
