Instrument Functions
NRP2
93User Manual 1173.9140.02 ─ 07
Open
Opens the selected window with its previous settings, i.e. "Open" restores a measure-
ment that has been removed from the display.
Remote command:
DISPlay[:
WINDow]<[1]..4>[:STATe] on page 247
Init
Initializes the selected window, i.e. "Init" configures a completely new measurement
with preset values.
Close
Closes the selected window. The sizes of the remaining windows are adjusted accord-
ingly.
Remote command:
DISPlay[:WINDow]<[1]..4>[:
STATe] on page 247
Expand
Expands all open windows to the full display height. Only the selected window is dis-
played while the other windows are masked by the selected window. However, the
masked windows are still open and can be selected in the sequence "1 2 3 4" in the
windows menu or by means of the up/down cursor keys.
Full height windows display all relevant parameters. The enhanced control functions
offered by the "Trace & Statistics" mode are available only if the windows are full
height. For a graphical representation of the various window types and a description of
symbols see
chapter 3.6.1, "Window sizes and types", on page 57 and chapter 3.6.2,
"Special symbols", on page 58.
Remote command:
DISPlay[:WINDow]:SIZE on page 246
Arrange
Reduces the full height windows to their normal size. The windows are displayed
simultanously again.
Remote command:
DISPlay[:
WINDow]:
SIZE on page 246
4.3.3.3 Selecting the result display mode
Three result display modes are available in the windows menu. The result display
mode determines how the measured values are presented.
Dig D&A Graph
Selects the display mode.
The parameter settings below the display mode change according to the selected
mode, see chapter 4.3.3.4, "Configuring the result display", on page 95.
Displaying measurement results
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
