Remote Control - Commands
NRP2
200User Manual 1173.9140.02 ─ 07
Command Preset and *RST value Remark
DISP<[1]..4>:MET:LOW -90 DBM
-120 DB
Lower limit value for analog result
display.
DISP<[1]..4>:MET:UPP 70 DBM
60 DB
Upper limit value for analog result
display.
DISP<[1]..4>:NAME ""
Text to be displayed in result win-
dow.
DISP<[1]..4>:RES 0.01
Measurement accuracy and dis-
play accuracy.
DISP:SEL 1
Selection of first result window.
DISP:SIZE NORM
Automatic window sizes.
DISP<[1]..4> ON | OFF
A window will automatically be
opened for each sensor.
DISP<[1]..4>:TRAC:LOW -120 DBM
Lower limit of power axis in Trace
mode
DISP<[1]..4>:TRAC:UPP 30 DBM
Upper limit of power axis in Trace
mode
DISP<[1]..4>:TSL 1
First timeslot
DISP<[1]..4>:UPD NORM
Frequent display updates.
FORM ASC
Measured data in ASCII format.
FORM:BORD NORM
"Big-Endian" byte sequence of
measured data, if FORMat
REAL
is selected.
INIT[1..4|:
ALL]:CONT ON
OFF
PRES and SYSTem:PRESet
.
*RST
INIT[1..4|:ALL]:DIS OFF
MEM:… -
The settings in the MEMory
com-
mand system will not be affected.
OUTP:REC1:
FEED "CALC1"
Analog outputs are fed by the first
calculate block.
OUTP:REC2:FEED "CALC2"
Analog outputs are fed by the sec-
ond calculate block.
OUTP:REC[1..2]:LIM:LOW
-20 DBM or
0 DB
0 V equivalent at analog output.
OUTP:REC[1..2]:LIM:UPP
20 DBM or
10 DB
3 V equivalent at analog output.
OUTP:REC1:STAT ON
Analog output active.
OUTP:REC2:STAT OFF
Trigger input active.
OUTP:ROSC OFF
Test generator is switched off.
Common Commands to IEEE 488.2
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
