Remote Control - Commands
NRP2
321User Manual 1173.9140.02 ─ 07
Parameters:
<state> 0 | 1 | 2
*
RST: This setting is not changed by *RST.
SYSTem:COMMunicate:INET[:SELF]:ADDRess
<ip1>,<ip2>,<ip3>,<ip4>
Sets the IP address of the R&S NRP2.
Note: This command cannot be used, while VXI11 or Ethernet is in use.
Note: Choosing an invalid IP-Address may disturb the traffic on your LAN. If you are
not sure how to configure these settings, please ask your network administrator.
Parameters:
<ip1>,<ip2>,<ip3>,<ip4>int_values
The four parameter form the IP address
<ip1>.<ip2>.<ip3>.<ip4>. For example, IP address 104.0.0.255
is entered as SYSTem:COMMunicate:
INET:ADDRess
108,0,0,255.
Range: 0...255 for each part of the IP address
*RST: This setting is not changed by *RST.
Usage: Event
SYSTem:COMMunicate:INET[:SELF]:GATEway:ADDRess
<gwip1>,<gwip2>,<gwip3>,<gwip4>
Sets the gateway address of your local subnet.
Note: This command cannot be used, while VXI11 or Ethernet is in use.
Note: Choosing an invalid Gateway-Address may disturb the traffic on your LAN. If you
are not sure how to configure these settings, please ask your network administrator.
Parameters:
<gwip1...4> int_value
Range: 0...255
*RST: This setting is not changed by *RST.
Usage: Event
SYSTem:COMMunicate:INET[:SELF]:SUBNetmask:ADDRess
<sm1>,<sm2>,<sm3>,<sm4>
Sets the subnet mask of your local subnet.
Note: This command cannot be used, while VXI11 or Ethernet is in use.
Note: Choosing an invalid subnet mask address may disturb the traffic on your LAN. If
you are not sure how to configure these settings, please ask your network administra-
tor.
SYSTem
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
