Remote Control - Commands
NRP2
324User Manual 1173.9140.02 ─ 07
SYSTem:KEY <key_stroke>
This command is used for testing purposes only and simulates a single stroke of an
R&S NRP2 frontpanel key.
The key stroke to be simulated is described either in plain text (<character_value>)
or by a key code (<NR1>) , see following table.
Table 6-34: Valid parameter values for the SYSTem:KEY command.
Simulated front-panel key <character_value> <NR1>
"Softkey toggle 1 left"
SK1L 1
"Softkey toggle 1 right"
SK1R 2
"Softkey toggle 2 left"
SK2L 3
"Softkey toggle 2 right"
SK2R 4
"Softkey toggle 3 left"
SK3L 5
"Softkey toggle 3 right"
SK3R 6
"Softkey toggle 4 left"
SK4L 7
"Softkey toggle 4 right"
SK4R 8
"Softkey toggle 5 left"
SK5L 9
"Softkey toggle 5 right"
SK5R 10
"Softkey toggle 6 left"
SK6L 11
"Softkey toggle 6 right"
SK6R 12
(PRE)SET
PRESet 13
ZERO
ZERO 14
FREQ
FREQ 15
MODE
Ⓘ Power
POWer 17
DEL / 1 TRIG
DELete 18
↵MENU
ENTer 19
ESC / LOCAL
ESCape 20
⇧
UP 21
⇩
DOWN 22
⇦
LEFT 23
⇨
RIGHt 24
Note:
The R&S NRP2 can be switched off via remote control by means of the SYSTem:KEY
POWER
command.
SYSTem
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
