Rohde & Schwarz R&S ZNB - Page 1283

Command Reference
R&S
®
ZNB/ZNBT
1283User Manual 1173.9163.02 ─ 53
SYSTem:CORRection:WIZard[:IMMediate] <Dialogs>
Keysight-compatible command to open the Start Cal Tab or the Calibration Kits Dialog.
Tip: When working with the Chapter 7.1.3, "GPIB Explorer", on page 715, switch to
raw mode ("Options">"Raw mode" in the IECWIN32 GUI) before executing this com-
mand.
Setting parameters:
<Dialogs> MAIN | CKIT
MAIN: open the "Calibration > Start Cal" softtool tab
CKIT: open the "Calibration Kits" dialog
Usage: Setting only
SYSTem:DATE
<Year>, <Month>, <Day>
The command queries or defines the instrument's current date setting.
The setting command requires administrator rights; refer to Chapter 11.1.1, "Windows
Operating System", on page 1379.
Parameters:
<Year> Year, four-digit number
<Month> Month, two-digit number, 01 (for January) to 12 (for December)
<Day> Day, two-digit number, 01 to the number of days in the month
Example:
SYST:DATE?
Response: 2012,05,01 - it is the 1st of May, 2012.
SYSTem:DFPRint?
Queries the device footprint. The device footprint contains detailed information about
the instrument and is mostly used for service purposes.
Usage:
Query only
Manual operation: See "Save... / Print... / Save Report" on page 684
SYSTem:DISPlay:BAR:HKEY[:STATe] <Boolean>
SYSTem:DISPlay:BAR:MENU[:STATe] <Boolean>
SYSTem:DISPlay:BAR:STATus[:STATe] <Boolean>
SYSTem:DISPlay:BAR:STOols[:STATe] <Boolean>
SYSTem:DISPlay:BAR:TITLe[:STATe] <Boolean>
SYSTem:DISPlay:BAR:TOOLs[:STATe] <Boolean>
Displays or hides the hardkey panel (HKEY), the menu bar below the diagram area
(MENU), the status bar below the diagram area (STATus), the softtool panel (STOols),
the title bar of the main VNA application window (TITLe), and the toolbar above the
diagram area (TOOLs).
SCPI Command Reference