<External sequencer settings>
* For the procedure of making each setting, refer to the
owner’s manual for your external sequencer.
■ Transmit Channel
The transmit channel of the track you want the JP-8080 to
play must be set to match the Part MIDI channel of the JP-
8080. The transmit channels of tracks you want the external
MIDI sound module to play must be set to match the
receive channels for each part of the external MIDI sound
module.
■ Thru Function
Turn this on. Musical data received at the MIDI IN of the
external sequencer will be transmitted from MIDI OUT
without modification.
* If your external sequencer does not have a Thru func-
tion, turn on the Local Switch of the JP-8080.
■ Tempo
Play the metronome and set a tempo that will be confort-
able for recording.
Recording Procedure
1 Use MIDI cables to connect the JP-8080, MIDI key-
board, and external sequencer as shown on page
145.
2 Make settings on the JP-8080, MIDI keyboard, and
external sequencer as explained in the above sec-
tion “Settings for Recording.”
3 Put the external sequencer in record mode, and
record your performance.
While listening to the metronome of the external
sequencer, record the rhythm parts etc. first.
4 In the same way, record the remaining parts.
For the track(s) to be played on the JP-8080, you can record
JP-8080 control movements and motions in the same way.
* Some sequencers are not able to record exclusive mes-
sages. In this case, assign MIDI messages such as control
changes to the controller whose movements you wish to
record. (“Tx/Rx Setting (Transmit/Receive Setting)”
(p.125).)
* You can also record arpeggios, patterns, motions, and
chorus/delay/LFO 1/ensemble/Voice Modulator delay
in synchronization to the MIDI Clock of the external
sequencer. For details on synchronization, refer to
“Synchronizing to an External MIDI Devices” (p.144).
Various Ways to Use
Voice Modulator
This section explains the settings that will be necessary
when you wish to use external sounds or sounds that were
synthesized by the JP-8080 to obtain formant filter or filter
bank effects.
Inputting an External Sound Directly
Into the Voice Modulator
(1) Formant filter
1 As shown in the diagram, connect your external
device or mic to the JP-8080.
2 Execute the Voice Modulator Initialize operation.
[INIT/UTIL]: VMod Init (p.106)
Initialize to one of the following: F.FLT: VINTAGE/
F.FLT: SILKY/F.FLT: HUSKYVOICE/F.FLT: BREAK-
BEATS.
3 Use the EXTERNAL INPUT [INST/LOWER] to
adjust the volume of the external input, and use
[VOCAL/UPPER] to adjust the volume of the mic
input.
To Next Page
Loading...
