Roland JP-8080 - Restoring Saved Settings to the JP-8080

Restoring Saved Settings to
the JP-8080
If you wish to modify the settings that have been saved on a
memory card, or to use the system settings that have been
saved on a memory card, use the following procedure to
restore the saved settings to internal memory.
* When data is restored to internal memory, the data
which had been in internal memory will be overwritten
and lost. However, the factory-set data can be recovered
by performing the Factory Reset operation. (p.140)
■ Restoring performance data to internal
memory (PERFORMANCE)
1 Make sure that a memory card has been inserted
into the card slot.
2 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
3 Press [INIT/UTIL] (BANK [7]) several times to
access the Card display.
The [INIT/UTIL] indicator will light.
4 Use [DEC]/[INC] several times to choose “CARD->USER.”
5 Press [WRITE].
6 Use [DEC]/[INC] several times to choose “PERFOR-
MANCE.”
7 Press [WRITE].
8 Press [DEC]/[INC] several times to select the con-
tents that will be restored.
CARD**: Performances of CARD**
** : 01–32 (for the S2M-5 (2M bytes))
** : 01–64 (for the S4M-5 (4M bytes))
9 Press [WRITE].
A confirmation message will appear.
To cancel without restoring, press [EXIT].
10 Press [WRITE].
The display will indicate “Completed.”
The performance data has now been restored to internal
memory.
11 Press [EXIT] to return to the previous display.
■ Restoring patch data to internal memory
(PATCH)
Patch data can be restored to internal memory in three
ways: both A and B, only A, or only B.
1 Make sure that a memory card has been inserted
into the card slot.
2 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
3 Press [INIT/UTIL] (BANK [7]) several times to
access the Card display.
The [INIT/UTIL] indicator will light.
4 Use [DEC]/[INC] several times to choose “CARD->USER.”
5 Press [WRITE].
6 Use [DEC]/[INC] several times to choose “PATCH.”
7 Press [WRITE].
8 Press [DEC]/[INC] several times to select the con-
tent that will be restored.
CARD** A&B: Patches of CARD** A, B
CARD** A: Patches of CARD** A
CARD** B: Patches of CARD** B
** : 01–32 (for the S2M-5 (2M bytes))
** : 01–64 (for the S4M-5 (4M bytes))
9 Press [WRITE].
10 Press [DEC]/[INC] several times to select the restore
destination.
* If you selected CARD** A&B in step 8, this setting will
not be necessary.
11 Press [WRITE].
A confirmation message will appear.
To cancel without restoring, press [EXIT].
12 Press [WRITE].
The display will indicate “Completed.”
The patch data has now been restored to internal memory.
13 Press [EXIT] to return to the previous display.
134