Roland JP-8080 - If You Make a Mistake While Recording

48
16 While playing back the pattern that you created in the previous section, press MOTION
CONTROL [2] and listen to the sound of the recorded motion change.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
◆ For details on recording settings
➜ “Settings for Recording” (p.100)
◆ For details on recording
➜ “Recording a Motion” (p.100)
◆ A recorded motion can also be saved to a memory card.
➜ “Saving Motion Control to a card (MOTION CONTROL)” (p.131)
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
■ If You Make a Mistake While Recording•••••••••••••••••••••
If you make a mistake while recording a Motion, use the following procedure to correct it.
If you don’t like the Motion that you recorded
When a Motion is recorded, movements of the same slider/knob are overwritten. This means that if you
wish to re-do a Motion, simply re-record the movement of that slider/knob. The old movement will be
overwritten by the newly recorded movement.
If you moved the wrong slider or knob by mistake
If you moved the wrong slider or knob, use the following procedure to erase the movements of that slider
or knob.
1 Hold down [REC] and press MOTION CONTROL [2].
The [REC] and [2] indicators will blink.
2 Press [ERASE] (NUMBER [5]).
The indicator will light, and the following display will appear.
14,52 1,6