Selecting Performances from
an External Device
You can select performances by transmitting Bank Select
(controller number 0, 32) and Program Change messages
from a connected MIDI keyboard etc. to the JP-8080. In this
case, the settings will differ slightly depending on whether
the external MIDI device is connected to the REMOTE KBD
IN connector or to the MIDI IN connector.
Connection to the REMOTE KBD IN connector
1 Use a MIDI cable to connect the MIDI OUT connec-
tor of the external MIDI device to the JP-8080’s
REMOTE KBD IN connector.
2 Press [PERFORM/PATCH SELECT] so that the
upper left of the display reads “PERFORM.”
3 Set the JP-8080’s Remote Keyboard Channel
(Remote KBD CH) either to ALL or to the same
number as the transmit channel of your external
MIDI device.
1) Press [EDIT]. (The indicator will light.)
2) Press [MIDI](BANK[5]) several times to select
“Remote KBD CH.”
3) Press [DEC]/[INC] to set the channel.
* After making the setting, be sure to press [EDIT] or
[EXIT] so that the upper left of the display reads “PER-
FORM.“
4 Transmit a Bank Select MSB (controller number 0)
message to the JP-8080.
5 Transmit a Bank Select LSB (controller number 32)
message to the JP-8080.
6 Transmit a Program Change message to the JP-8080.
Connection to the MIDI IN connector
1 Use a MIDI cable to connect the MIDI OUT connec-
tor of the external MIDI device to the JP-8080’s
MIDI IN connector.
2 Set the JP-8080 Performance Control MIDI channel
to match the transmit channel of the external MIDI
device.
1) Press [EDIT]. (The indicator will light.)
2) Press [MIDI] (BANK [5]) several times to select
“Perform Ctrl CH.”
3) Use [DEC]/[INC] to set the channel.
3 Set the Program Change Transmit/Receive Switch
to BANK SEL + PC.
1) Press [MIDI] (BANK [5]) several times to select
“Tx/Rx ProgChg SW.”
2) Use [DEC]/[INC] to select “BANK SEL + PC.”
* After making the setting, be sure to press [EDIT] or
[EXIT] to make the upper left of the display read “PER-
FORM” or “PATCH.”
4 Transmit a Bank Select MSB (controller number 0)
message to the JP-8080.
5 Transmit a Bank Select LSB (controller number 32)
message to the JP-8080.
6 Transmit a Program Change message to the JP-8080.
* When the JP-8080 receives only a Program Change mes-
sage without receiving Bank Select messages,
Performances within the same group will be selected.
* If a Bank Select message other than those listed in the
table on page 176 is received, that Bank Select message
will be ignored, and Performances will be selected with-
in the same group.
For the correspondence between the bank select (CC#0,
CC#32) / program numbers (PC#) which are transmitted
and the performances, refer to “Performance List (p.176).”
Selecting a Key Mode
The Key Mode specifies how the two patches assigned to
the performance will be sounded.
SINGLE: Either the Upper or the Lower patch will sound.
DUAL: The Upper and Lower patches will sound together.
SPLIT: Divided at a specified key (Split Point), the Lower
patch will sound in the left side of the keyboard, and the
Upper patch in the right side.
1 Press [KEY MODE] to select the mode.
The indicator of the selected mode will light.
2 If SINGLE is selected, use the PANEL SELECT
[LOWER]/[UPPER] buttons to select the part whose
patch you will play.
* It is possible to change the Split Point. (p.116)
60
To Next Page
Loading...
