83
When the MIDI keyboard is played with different velocities,
the various parameter values will change in the amount
specified by step 4, relative to the current slider/knob posi-
tions.
This means that if you move the sliders/knobs after making
settings, this will change the parameter values that are pro-
duced when you play at the standard velocity. The width of
the change will not be affected.
* When you wish to check the width of the parameter
change, press [VELOCITY ASSIGN] while appearing the
Temporary Scope display, and then move the
sliders/knobs (Velocity Scope: p.63).
* If you wish to view the width of parameter change in
the display as you adjust the setting, press [VELOCITY
ASSIGN] when the Edit Scope page is desired, and then
move the slider/knob (Velocity Edit Scope: p.64).
* If velocity is used simultaneously with Control Assign
(p.84), Vocal Morph Contorl (p.104) or Motion Control
(p.98), any overlapping parameters will have their val-
ues added to produce the resulting change.
● Brass instrument attacks
On brass instruments such as the trumpet, an “instability in
pitch” occurs when breath is first blown into the instru-
ment. The degree of this instability depends on the force of
the breath.
By setting OSC COMMON [LFO 1 & ENV DESTINATION]
to OSC 1+2, and setting PITCH ENVELOPE [DEPTH] and
AMP [LEVEL] for velocity, softly played notes will have lit-
tle pitch change, and strongly played notes will have a large
pitch change, producing a more realistic simulation of a
brass instrument.
Canceling the Settings of a
Parameter
If you wish to cancel the settings only for a specific parame-
ter of the parameters being controlled, use the following
procedure to set the width of change to 0 for that parameter.
1 Move the slider/knob to the lowest (or the far left)
position for the parameter whose settings you wish
to cancel.
2 Press MORPHING [VELOCITY ASSIGN].
The indicator will blink, and the velocity assign page
will appear.
3 Slightly raise (or rotate to the right) the slider/knob,
and then return it to the lowest (far left) position.
4 Press [VELOCITY ASSIGN] or [EXIT].
The indicator will light (or go dark if all parameters
were canceled), and the previous display will reappear.
The parameter settings have now been canceled.
5 Move the slider/knob to the desired position.
* It is also possible to use Velocity Edit Scope (p.64) to set
the width of parameter change to zero.
Canceling the Settings of
All Parameters
1 Press MORPHING [VELOCITY ASSIGN].
The indicator will blink, and the velocity assign page
will appear.
2 Press [WRITE].
The display will indicate “Completed.”
All parameter settings have now been canceled.
3 Press [VELOCITY ASSIGN] or [EXIT].
The indicator will go dark, and the previous display will
reappear.
To Next Page
Loading...
