163
Morphing
Appendices
Let’s create a sound using the Vocal Morph Control.
We will create a sound which allows you to transform an
electric piano sound into a strings sound by inputting your
voice.
1 Connect a mic (sold separately) to the MIC jack.
2
In the EXTERNAL INPUT section, turn [REAR/FRONT]
on (FRONT) to make the indicator light.
3
In the EXTERNAL INPUT section, use [VOCAL/UPPER]
to adjust the input level of your voice.
4 Execute the Initialize operation to set the perfor-
mance to the basic settings.
[INIT/UTIL]: Initialze: PERF: TEMPORARY
5 Execute the Voice Modulator Initialize operation to
make settings so that Vocal Morph Control can be
used immediately.
[INIT/UTIL]: VMod Init: VOCAL MORPH CTRL
Now let’s create the electric piano sound.
6 In the OSC1 section, set [WAVEFORM] to “SUPER
SAW.”
7 In the OSC1 section, set [CONTROL 1](DETUNE)
and [CONTROL 2](MIX) to the positions shown in
the diagram.
8 In the FILTER section, set [CUTOFF FREQ] to the
position shown in the diagram.
9 FILTER ENVELOPE section, set all sliders to the
positions shown in the diagram.
10
In the AMP section, set [LEVEL] to the maximum
position.
11
In the AMP ENVELOPE section, set all sliders to
the positions shown in the diagram.
12
Set [MULTI-FX LEVEL] to the minimum position.
13
Move DELAY [TIME] and [FEEDBACK] to the posi-
tions shown in the diagram, and set [LEVEL] to the
minimum position.
This completes our electric piano sound.
14
Press [CONTROL ASSIGN] to make the indicator
blink.
To Next Page
Loading...
