Morphing (continued)
164
15
Next we will specify the width of change for the
parameters that will be controlled by changes in
your voice.
The following parameters will be modified. Make set-
tings as shown in the diagram.
• OSC1 section [CONTROL 1] (DETUNE)
• FILTER section [CUTOFF FREQ]
• FILTER ENVELOPE section [S] [R]
• AMP ENVELOPE section [A] [S] [R]
• [MULTI-FX LEVEL]
• DELAY [LEVEL]
If you input an “a” sound from the mic as you make
these settings, you will be able to hear the way in which
the settings affect the sound.
16
Press [CONTROL ASSIGN] to make the indicator
light.
17
Return the sliders/knobs which you set in step 15 to
the positions in which they were for the electric
piano sound.
18
Sing or speak an “a” sound into the mic.
The electric piano sound will change into a strings
sound.
This same effect can also be produced by receiving the
MIDI messages specified for Control Up ([MIDI]) (Control
Assign: p.84). When using MIDI messages to produce this
change, turn off the VOICE MODULATOR section [ON], so
that noise picked up by the mic does not cause the sound to
change.
To Next Page
Loading...
