155
While you are creating a strings sound, it is a good idea to
audition the sound by playing chords of four notes or so.
This will give you a better idea of the character of the sound
then if you play only an individual note.
1 Use the Initialize operation to set the Performance
to the basic settings.
[INIT/UTIL]: Initialze: PERF: TEMPORARY
2 For the OSC1 section [WAVEFORM], select SUPER
SAW.
3 Move the OSC1 section [CONTROL 1] (DETUNE)
to the position shown in the diagram.
4 Move the OSC1 section [CONTROL 2] (MIX) to the
maximum position.
This will produce the impression of a larger ensemble of
strings.
5 Move the AMP ENVELOPE section [R] to the posi-
tion shown in the diagram, so that the sound will
linger for a time after the key is released.
6 Move the AMP ENVELOPE section [A] to the posi-
tion shown in the diagram, so that the attack will be
a bit slower.
7 Set [MULTI-FX LEVEL] to the maximum setting.
This will give the sound greater breath and depth.
8 Set the DELAY [LEVEL] to the maximum setting.
This will add reverberation.
Appendices
Strings
To Next Page
Loading...
