133
Erasing a Pattern/Motion That
was Saved on a Memory Card
In some cases when you attempt to save data to a memory
card, an indication of "Card Memory Full!" will appear, and
it will not be possible to save the data. This occurs when the
memory card contains patterns or motions which contain
large amounts of data. In such cases, you can erase individ-
ual patterns or motions from a memory card.
* It is not possible to erase performance, patch, or system
settings.
1 Make sure that a memory card is inserted into the
memory card slot.
2 Press [EDIT].
The [EDIT] indicator will light, and the BANK [1]–[8]
indicators will blink.
3 Press [INIT/UTIL] (BANK [7]) several times to
select the Card page.
The [INIT/UTIL] indicator will light.
4 Press [DEC]/[INC] several times to select “ERASE.”
5 Press [WRITE].
6 Press [DEC]/[INC] several times to select “PAT-
TERN” or “MOTION CONTROL.”
7 Press [WRITE].
8 Press [DEC]/[INC] several times to select the con-
tents which will be erased.
(For a PATTERN)
CARD C#2: pattern C#2
:
CARD C 6: pattern C 6
(For a MOTION CONTROL)
CARD* SET A[1]: CARD* motion [1] of SET A
CARD* SET A[2]: CARD* motion [2] of SET A
CARD* SET B[1]: CARD* motion [1] of SET B
CARD* SET B[2]: CARD* motion [2] of SET B
* : 1 or 2
9 Press [WRITE].
A message will ask for confirmation.
If you decide not to erase the data, press [EXIT].
10
Press [WRITE].
The display will indicate "Completed."
The specified pattern or motion has now been erased.
11
Press [EXIT] to return to the previous display.
Chapter
10
To Next Page
Loading...
