63
Editing a Patch
You can move the sliders and knobs etc. of the front panel
to modify the sound of the selected Patch.
1 Use PANEL SELECT [LOWER]/[UPPER] to select
the Part whose Patch you wish to edit.
If you press both [LOWER] and [UPPER] simultaneous-
ly, both indicators will light, and you can simultaneous-
ly edit the Patches of both Parts.
In this case, the panel will show the settings of the
Upper Patch.
2 Use the panel sliders and knobs etc. to edit the
Patch.
* When the [UPPER] and [LOWER] indicators are blink-
ing, moving the panel sliders/knobs displayed in blue
will edit the Voice Modulator parameters. (p.111)
Checking the Current Value of a
Parameter (Temporary Scope)
When you wish to check the current value of a parameter
(the parameter value in the temporary area), use the follow-
ing procedure to view the value.
* While Temporary Scope page is displayed, the parame-
ters will not edit if you move the sliders/knobs.
* The values of the following knobs cannot be viewed in
the display.
• VOLUME [LEVEL]
•
EXTERNAL INPUT [INST/LOWER] and [VOCAL/UPPER]
1 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
2 Press [SCOPE] (BANK [8]) to access the Temporary
Scope display.
The [SCOPE] indicator will light.
3 Move the slider/knob of the parameter whose value
you wish to check.
The parameter name and temporary value of the slid-
er/knob you moved will appear in the display.
By pressing [DEC]/[INC] you can modify the value in
steps of 1.
* If at this time you press [SCOPE], the lower left of the
display will indicate (Edit), and you will enter Edit
Scope mode (see following section).
4 To end Temporary Scope, press [EDIT] or [EXIT].
* If you use the Temporary Scope when the Voice
Modulator panel (p.111) is selected, an “x” will some-
times appear in the display. This indicates that when the
algorithm (p.108) is set to “FLT BANK WIDE” or “FLT
BANK NARROW,” this parameter is invalid.
■ Velocity Scope and Control Scope
The width of change for the various parameters assigned to
Velocity (p.82) or Control (p.84) can be verified in the dis-
play.
1 When the Temporary Scope page is displayed,
press [VELOCITY ASSIGN] or [CONTROL
ASSIGN].
The indicator will blink, and the display will indicate
either “Velocity Scope” or “Control Scope.”
2 Move the slider/knob whose value you wish to veri-
fy.
The parameter and width of change for the slider/knob
you moved will be displayed.
You can use [DEC]/[INC] to modify the value in steps
of one.
* If at this point you press [SCOPE] (BANK [8]), the dis-
play will indicate (E), and you will enter the correspond-
ing Edit Scope (refer to the following section).
3 When you press [VELOCITY ASSIGN], [CON-
TROL ASSIGN] or [EXIT], you will return to the
Temporary Scope page.
Chapter 2
To Next Page
Loading...
