BRP-Rotax
MAINTENANCE MANUAL LINE
Points of Inspection
Interval Operating hours Chapter
Reference
Signa-
ture
* no periodic maintenance require-
ment after the first 25 hours of
operation
25* 50 100 200 600 1000
Inspect all oil lines for damage, leak-
age, hardening from heat, porosity, se-
curity of connections and attachments.
Verify routing is free of kinks and
restrictions.
X X X X X 12–20–00
Leakage
check
Inspect all fuel lines for damage, leak-
age, hardening from heat, porosity, se-
curity connections and attachments.
Verify routing is free of kinks and re-
strictions. Check steel fuel lines for any
cracks and/or scuffing marks.
X X X X X 12–20–00
Checking the
fuel lines
Inspect the wiring (wiring harness) and
its connections for secure fit, damage
and signs of wear.
X X X X 12–20–00
Check of
wiring
Inspect engine suspension and fasten-
ers (GENUINE ROTAX®) for secure fit,
including damage from heat, deforma-
tion, cracks.
X X X X X 12–20–00
Checking the
engine
suspension
Check the airbox (GENUINE ROTAX®)
incl. throttle body actuation. Inspect
sensors for tight fit, damage from heat,
damage and signs of wear.
X X X X X
Checking the air filter.
X X X X X 12–20–00
Cleaning the
dry air filter
Inspection of the GENUINE ROTAX®
exhaust system included in the stand-
ard delivery.
NOTE
If there is no GENUINE ROTAX®
exhaust system in use, the specifi-
cations of the manufacturer must
be observed.
X X X X
8) Oil change
Drain oil from oil tank.
X X
(5
X X X X 12–20–00
Oil change,
Flushing the
oil circuit
05–20–00
Page 12
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0