EasyManuals Logo

Rotax 912 Series Service Manual

Rotax 912 Series
456 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #376 background imageLoading...
Page #376 background image
76-00-00
page 44
May 01/2007
Effectivity 914 Series
Edition 1 / Rev. 0
d02626
BRP-Rotax
Maintenance Manual
3.1.2.6) Pressure sensors
See Fig. 76-43.
To prevent mixup of the two pressure sensor inputs, the plug
connections are in different colors. In addition, the airbox
pressure sensor cable set of the wiring harness is labeled.
Gray plug connection (1) - ambient pressure sensor
Black plug connection (2) - airbox pressure sensor
If a pressure sensor must be replaced, it is necessary to check
the current values via communication program (Monitoring).
See 76-00-00 sec. 3.1.
If this aid is not at your disposal, an engine test run has to be
performed. See corresponding Maintenance Manual (Line
Maintenance) for the respective engine type 914 Series.
â–² WARNING: If an inspection reveals irregularities, then the
engine must not be taken in operation until the
cause is found and rectified.

Table of Contents

Other manuals for Rotax 912 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 912 Series and is the answer not in the manual?

Rotax 912 Series Specifications

General IconGeneral
Redline5800 rpm
TBO2000 hours
Displacement1211 cc
Bore79.5 mm
Stroke61 mm
Power Output80 hp (59.6 kW)
Compression Ratio9.0:1
Fuel TypeAvgas 100LL
Ignition SystemDual electronic ignition
Fuel SystemFuel Injected
Oil SystemDry sump
Engine Type4-cylinder, horizontally opposed, 4-stroke

Related product manuals