Rotax 912 Series Service Manual

78-00-00
page 12
May 01/2007
Effectivity 912/914 Series
Edition 1 / Rev. 0
d02627
BRP-Rotax
Maintenance Manual
00162
3.3.3 Turbocharger
See Fig. 78-4
Visual inspection of the turbocharger.
◆ NOTE: The turbocharger is handled as a complete unit, i.e. no
spare parts are available from BRP-Rotax. In the event
of damage, the complete unit has to be replaced.
Inspect face of turbine inlet.
Check the wastegate lever for free movement. If it does not move
freely, lubricate the axle of the wastegate with LOCTITE Anti-Seize
8151, ROTAX part no. 297434.
■ CAUTION: On older engine versions, also observe SB-914-005,
“Introduction of a turbo charger with a modified
wastegate“, latest issue.
Fig. 78-4

Rotax 912 Series Specifications

General

Redline	5800 rpm
TBO	2000 hours
Displacement	1211 cc
Bore	79.5 mm
Stroke	61 mm
Power Output	80 hp (59.6 kW)
Compression Ratio	9.0:1
Fuel Type	Avgas 100LL
Ignition System	Dual electronic ignition
Fuel System	Fuel Injected
Oil System	Dry sump
Engine Type	4-cylinder, horizontally opposed, 4-stroke