Rotax 914 series Maintenance Manual

76-00-00
page 30
May 01/2007
Effectivity 914 Series
Edition 1 / Rev. 0
d02626
BRP-Rotax
Maintenance Manual
- Check the display at max. continuous performance.
■ CAUTION: Throttle lever must be in positive stop position.
nominal: 100 % max. deviation +3%.
▲ WARNING: This check of position is only meaningful and
permissible if idle- and full throttle-position are
within the permissible tolerances.
If the throttle position for idle and full throttle are not within the
permissible tolerances or if not proceeding linearly, then a new
calibration of the throttle position is absolutely necessary.
Recalibration to be carried out only by an authorized ROTAX-
Dealer or Service Center if the TCU is of part no. 966470 to
966473 .
If TCU part no. 966741 or higher is used, proceed with
calibration as described in the following section.

Rotax 914 series Specifications

General

Bore	79.5 mm
Stroke	61 mm
Compression Ratio	9.0:1
Cooling System	Liquid-cooled cylinder heads, air-cooled cylinders
Redline	5800 rpm
Engine Type	4-cylinder, 4-stroke
Fuel Type	Avgas 100LL
Oil System	Dry sump
Fuel System	fuel injection
TBO (Time Between Overhauls)	2000 hours
Displacement	1.211 liters (1211 cc)
Power Output	84.6 kW (115 hp) at 5, 800 rpm