rotork CK Series User Manual

Keeping the World Flowing
53
Setting Up and Maintaining the Profibus
®
Module
8.5 Setting up the remote source in a CK actuator
with the Setting Tool
The actuator requires the remote source to be set up into the
correct state otherwise the network will be unable to control
the actuator, example below:
PROFIBUS
OPTION 1
Refer to the installation manual of the actuator for more
details and the table on the previous page for information on
the menu layout.
8.6 Maintenance and Repair
There is no periodic service requirement for the PFU.
Repairs should not be attempted on the module. Replacing
the PFU with a new replacement device should rectify any
failure. Static sensitive devices are used in the PFU, it is
therefore mandatory to observe anti-static precautions when
handling or working on the unit.
A4 US
US
A4
US
A4
A4 US

rotork CK Series Specifications

General

Brand	rotork
Model	CK Series
Category	Controller
Language	English