Frequently asked questions
120
Ocean 2014 User's Manual
2014-06-02/3.2A
Where can I specify the scatter factor?
In Ocean the scatter factor is called "Beam correction factor". This factor can be used to apply a
correction on the measured exposure or exposure rate. You can find this parameter on the meter
adjust tabs for exposure detectors or in the grid if specified as column or general setting.
5.3 Data export to Excel or Calc
Can I export certain cells from an Ocean test to Excel?
Yes you can. You can use something that is called "Cell-to-cell". You can then "link" individual cells in
Ocean with individual cells in Excel. By doing this, you get full control over where your data appears in
the spreadsheet. You can read more in the topic Link a session to Excel.
5.4 Design
I cannot edit a set value in a test. Why?
This normally happens when you are working with a session and the template you are trying to edit
not open (active). You can look at all tests/checklists in a session, but you can only modify the one
that is currently active.
Can I change the acceptance limits in a test?
Yes. Right-click on the analysis window and click on "Modify analysis", select the analysis you want to
change the limits for. The limits are now shown and you can modify them. Read more in topic
Acceptance limits.
Can I have different acceptance limits for each row in a test?
Yes. Right-click on the analysis window and click on "Modify analysis", select the analysis you want to
change the limits for. The limits are now shown and you can modify them for individual rows. Read
more in topic Acceptance limits.
There are four different types of templates:
Test template
Checklist template
Session template
Real-time display template
A template is an object without any measured data but with all other necessary information to
perform a measurement and required analysis.
I want to see my exposure values both in "R" and "mGy". Can I do that?
Yes. You can just right-click on the column head and select "Unit" from the menu. If you are working
with a real-time display, just click on the unit in the display. A list with available units is shown, select
the unit you want.
Where can I specify the scatter factor?
In Ocean the scatter factor is called "Beam correction factor". This factor can be used to apply a
correction on the measured exposure or exposure rate. You can find this parameter on the meter
adjust tabs for exposure detectors or in the grid if specified as column or general setting.
To Next Page
Loading...
Need help?
General
