Ocean 2014 - Main screen
46
Ocean 2014 User's Manual
2014-06-02/3.2A
3 Ocean 2014 - Main screen
Main view when Ocean 2014 is in "full mode" (not in "quick check mode"):
Here is a picture of the Main screen. There is a lot of information on this screen so make sure you read
carefully your menu choices. All key functions are found on the "ribbon" bar for easy access. The ribbon is
divided into six tabs and each tab has a collection of similar functions:
Measure - here you will find everything related to measurements (such as detector selection, connect to
meter, set bias, get waveforms, etc.). Quick Check is started from this tab.
Design - under this tab you will find all the functions for creating, saving and editing templates
Data link - this tab has the choices for customizing your data link to Microsoft Excel
Appearance - you can change how things are shown on the main screen with these functions
Reporting - these are all the functions you need to create, edit and print out reports the way you like it
Help - get help
Just below the ribbon and on the bottom of the main screen you find two status bars.
The status bar located just below the ribbon status bar is divided into two parts: the left part indicates
what the meter is doing right now and the right part is used to display messages and information.
The status bar located at the very bottom of the main screen shows current meter being used, work
mode, battery indicator for the meter and more.
There are two tabs (Measurements and Library) located on the top left of the main screen just below
the ribbon.
Measurements - This is where you will find all your measured and saved data. The saved data from the
real-time display and Quick Check is also found here. If you are using Professional license, you can also see
your facilities, rooms and tubes here with their corresponding data.
Library - This is where all your templates are stored. A template is a "blank protocol" without any
measured data recorded.
To Next Page
Loading...
