To Next Page

To Previous Page

RTK Series 725 Annunciator

F9- Non-Critical Group Relay Reflash Function

Group relays are typically used to inform third party devices that there is an alarm within a local

panel, however in the standard mode additional alarms occurring within the same group will not

change the state of the relay if one alarm remains active. The reflash function allows the relay to

change state for 0.5 seconds every time a new alarm occurs within the same group.

FEATURE-F9 STATUS LED

Set channel to disable reflash function on non-critical group relay OFF

Set channel to enable reflash function on non-critical group relay ON

Please note:- Only alarms with function F22 set to on will activate the non critical group relay.

F10- First-Up Sequence FO Or Enable Slow Flash On Non-First Out

Sequences

This feature is used to enable first-up sequence FO on individual channels as required. Full

sequence tables are provided in Section 10

FEATURE-F10 STATUS LED

Set channel to first-up sequence FO not required OFF

Set channel to first-up sequence FO required ON

Please note:- F10 is used to enable slow flash for non first up sequences.

F11- First-Up Sequence F1

This feature is used to enable first-up sequence F1 on individual channels as required. Full sequence

tables are provided in Section 10

FEATURE-F11 STATUS LED

Set channel to first-up sequence F1 not required OFF

Set channel to first-up sequence F1 required ON

F12- First-Up Sequence F2

This feature is used to enable First-Up sequence F2 on individual channels as required. Full

sequence tables are provided in Section 10

FEATURE-F12 STATUS LED

Set channel to first-up sequence F2 not required OFF

Set channel to first-up sequence F2 required ON

F13- First-Up Sequence F3 Or Enable Fast Flash On Non-First Out Sequences

This feature is used to enable first-up sequence F3 on individual channels as required. Full sequence

tables are provided in Section 10

FEATURE-F13 STATUS LED

Set channel to first-up sequence F3 not required OFF

Set channel to first-up sequence F3 required ON

Please note:- F13 is used to enable fast flash for non first out sequences

RTK 725 Series User Manual

Other manuals for RTK 725 Series